Ip Ospf Priority; Ip Ospf Transmit-Delay; Ip Ospf Retransmit-Interval; Ip Ospf Hello-Interval - Belden HIRSCHMANN EAGLE40-07 Referenzhandbuch

Parameter Value
broadcast
P-1
nbma
point-to-point
point-to-multipoint
2 1 .2 .4 ip ospf priorit y
Configure the OSPF router priority which the router uses in multi-access networks for the designated router
election algorithm. The router with the higher router priority is the designated router. A value of 0 declares the
router as ineligible for designated router elections.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip ospf priority <P-1>
Parameter Value
0..255
P-1
2 1 .2 .5 ip ospf t ra nsm it -de la y
Configure the OSPF transmit-delay for the interface, in seconds. The transmit-delay is the time that you estimate
it takes to transmit a link-state update packet over the interface.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip ospf transmit-delay <P-1>
Parameter Value
0..3600
P-1
2 1 .2 .6 ip ospf re t ra nsm it -int e rva l
Configure the OSPF retransmit-interval for the interface, in seconds. The retransmit-interval is the interval after
which link-state advertisements containing database description and link-state request packets, are re-transmitted
for adjacencies belonging to this interface.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip ospf retransmit-interval <P-1>
Parameter Value
0..3600
P-1
2 1 .2 .7 ip ospf he llo-int e rva l
Configure the OSPF hello-interval for the interface, in seconds. The hello timer controls the time interval between
two consecutive hello packets. Set this value to the same hello-interval value of the neighbor.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip ospf hello-interval <P-1>
Parameter Value
1..65535
P-1
2 1 .2 .8 ip ospf de a d-int e rva l
Configure the OSPF dead-interval for the interface, in seconds. If the timer expires without the router receiving
hello packets from the neighbor, the router declares the neighbor router as down. Set the timer to at least four
times the value of the hello-interval.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip ospf dead-interval <P-1>
Parameter Value
1..65535
P-1
RM CLI EAGLE40-07
Release 04.1.01 05/2021
Meaning
Configure the link-type as broadcast for the interface. In broadcast networks,
routers discover their neighbors dynamically using the OSPF hello protocol.
Configure the link-type as Non-Broadcast Multi-Access for the interface. The
nbma mode, emulates OSPF operation over a broadcast network. The nbma mode is
the most efficient way to run OSPF over non-broadcast networks, both in terms
of the LSDB size and the amount of routing protocol traffic. However, this mode
requires direct communication between every router in the nbma network.
Configure the link-type as point-to-point for the interface. Use the point-to-
point link-type in a network that joins a single pair of routers.
Configure the link-type as point-to-multipoint for the interface. In the point-
to-multipoint mode, OSPF treats each router-to-router link over non-broadcast
networks as if they were point-to-point links.
Meaning
Configure the priority.
Meaning
Enter a number in the given range.
Meaning
Enter a number in the given range.
Meaning
Enter a number between 1 and 65535
Meaning
Enter a number between 1 and 65535
81