Ip Ospf Router-Id; Ip Ospf External-Lsdb-Limit; Ip Ospf Exit-Overflow; Ip Ospf Maximum-Path - Belden HIRSCHMANN EAGLE40-07 Referenzhandbuch

Parameter Value
1..16777214
P-1
2 1 .1 .6 ip ospf rout e r-id
Configure the router ID to uniquely identify this OSPF router in the autonomous system. If a tie occurs during the
designated router election, the router with the higher router ID is the designated router.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf router-id <P-1>
Parameter Value
A.B.C.D
P-1
2 1 .1 .7 ip ospf e x t e rna l-lsdb-lim it
Configure the OSPF external lsdb limitation, which is the maximum number of non-default AS-external-LSA
entries that the router stores in the link-state database. When the value -1 is configured, you disable the limitation.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf external-lsdb-limit <P-1>
Parameter Value
-1..2147483647
P-1
2 1 .1 .8 ip ospf e x it -ove rflow
Configure the OSPF exit overflow interval, in seconds. After the timer expires the router will attempt to leave the
overflow-state. To disable the exit overflow interval function set the value to 0.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf exit-overflow <P-1>
Parameter Value
0..2147483647
P-1
2 1 .1 .9 ip ospf m a x im um -pa t h
Configure the maximum number of paths that OSPF reports.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf maximum-path <P-1>
Parameter Value
1..4
P-1
2 1 .1 .1 0 ip ospf spf-de la y
Configure the SPF delay, in seconds. The Shortest Path First (SPF) delay is the time that the device waits for the
network to stabilize before calculating the shortest path tree, after a topology change.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf spf-delay <P-1>
Parameter Value
0..65535
P-1
2 1 .1 .1 1 ip ospf spf-holdt im e
Configure the minimum time between two consecutive SPF calculations, in seconds.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf spf-holdtime <P-1>
Parameter Value
0..65535
P-1
2 1 .1 .1 2 ip ospf a ut o-c ost
Set the auto cost reference bandwidth of the router interfaces for ospf metric calculations. The default reference
bandwidth is 100 Mbps.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf auto-cost <P-1>
78
Meaning
Configure the default metric for redistributed routes.
Meaning
IP address.
Meaning
Configure the external lsdb limit.
Meaning
Configure the exit overflow interval.
Meaning
Set the maximum path.
Meaning
Enter a number between 0 and 65535
Meaning
Enter a number between 0 and 65535
RM CLI EAGLE40-07
Release 04.1.01 05/2021