1 De E P Pa Cke T I Nspe C T Ion (Dpi ); Dpi; Dpi Modbus Commit; Dpi Modbus Addprofile - Belden HIRSCHMANN EAGLE40-07 Referenzhandbuch

1 1 De e p Pa cke t I nspe c t ion (DPI )

1 1 .1

dpi

Creation and configuration of DPI profiles.
1 1 .1 .1 dpi m odbus c om m it
Writes all changes made in the DPI MODBUS profiles to the enforcer.

Mode: Global Config Mode

Privilege Level: Operator

Format: dpi modbus commit
1 1 .1 .2 dpi m odbus a ddprofile
Adds a profile to the DPI MODBUS profile table.

Mode: Global Config Mode

Privilege Level: Operator

Format: dpi modbus addprofile <P-1> [description <P-2>] [function-type <P-3>]
[function-code-list <P-4>] [unit-identifier-list <P-5>] [sanity-check <P-6>]
[exception <P-7>] [reset <P-8>]
[description]: Profile description/name for the DPI MODBUS profile.
[function-type]: Function type of corresponding function codes.
[function-code-list]: Function code list. A function code has the syntax 'val'. Function codes are separated
by a comma. When more than one value for an function code is specified the values are separated by the pipe
symbol ('|').
[unit-identifier-list]: Unit identifier list. A unit identifier has the syntax 'val'. To specify no options, the
value 'none' must be given. Unit identifiers are separated by a comma.
[sanity-check]: Sanity check including format and specification.
[exception]: Device exception message.
[reset]: Reset connection message.
Parameter Value
1..32
P-1
string
P-2
readonly
P-3
readwrite
programming
all
advanced
46
Meaning
Profile index 1 - 32
Profile description/name
Read only function codes for function code list
Read write function codes for function code list
Programming function codes for function code list
All possible function codes for function code list (allow any function code)
Keeps the function code list from the previous selection and makes it editable
by the user
RM CLI EAGLE40-07
Release 04.1.01 05/2021