18Packet-Filter L2 Rule Modify - Belden HIRSCHMANN EAGLE40-07 Referenzhandbuch

Parameter Value
string
P-7
any
P-8
string
string
string
string
0x0600-0xffff
P-9
appletalk
arp
ibmsna
ipv4
ipv6
ipx-old
mplsmcast
mplsucast
netbios
novell
pppoedisc
rarp
pppoesess
ipxnew
profinet
powerlink
ethercat
vlan8021q
icmp
P-10
igmp
ipip
tcp
udp
esp
ah
any
1..4042
P-11
string
P-12
0..10000000
P-13
0..128
P-14
pps
P-15
kbps
0..255
P-16
enable
P-17
disable
enable
P-18
disable

no pa c k e t -filt e r l2 rule a dd
Disable the option

Mode: Global Config Mode

Privilege Level: Operator

Format: no packet-filter l2 rule add action [src-mac] [dst-mac] [src-ip]
[sourceport] [dest-ip] [destport] [ethertype] [proto] [vlan] [description]
[rate-limit] [tos] [log <P-17>] [trap <P-18>]
3 1 .1 .1 8 pa c k e t -filt e r l2 rule m odify
Modifies a rule to the L2 firewall table.

Mode: Global Config Mode

Privilege Level: Operator

Format: packet-filter l2 rule modify <P-1> action <P-2> [src-mac <P-3>] [dst-mac <P-
4>] [src-ip <P-5>] [sourceport <P-6>] [dest-ip <P-7>] [destport <P-8>] [ethertype
<P-9>] [proto <P-10>] [vlan <P-11>] [description <P-12>] [rate-limit <P-13> <P-
14> <P-15>] [tos <P-16>] [log <P-17>] [trap <P-18>]
action: Set Action
[src-mac]: Specify the source MAC address.
[dst-mac]: Specify the destination MAC address.
[src-ip]: Specify the source IP address/mask.
RM CLI EAGLE40-07
Release 04.1.01 05/2021
Meaning
Target IP address/CIDR mask/'any'
any Any port/portless protocol
a-b Port Range
a,b Port List (may be longer than two ports)
a-b,c-d List of Port Ranges (may be longer than two ranges)
1 to 65535 Port Number
value Ethertype
Appletalk
ARP
IBMSNA
IPv4
IPv6
IPX-OLD
MPLS Multicast
MPLS Unicast
NetBIOS
NOVELL
PPPOEDISC
RARP
PPPOESESS
IPXNEW
PROFINET
POWERLINK
ETHERCAT
IEEE802_1Q VLAN
Internet Control Message Protocol
Internet Group Management Protocol
IP-within-IP Encapsulation Protocol
Transmission Control Protocol
User Datagram Protocol
Encapsulating Security Protocol
Authentication Header
Any of the above
Enter a VLAN ID in the given range.
Rule description/name
Committed rate value, specified in kbps or pps.
Committed burst size value, specified in kbytes or pps.
Packets per second.
kbytes per second.
Specify the IP TOS bits to match.
Enable logging when applying the rule
Do not log applying the rule
Enable sending a trap when applying the rule
Do not send a trap when applying the rule
121