Enraf Nonius Radarmed 950+ Gebrauchsanweisung Seite 47


Indicate in which range (in Watt) the power setting will
probably be set (minimum and maximum value).

Operate "Program store key" [2]. In the upper right corner
ofthe display [12] the program number flashes (e.g. #1).

Select by means of the "Central control" [8] in which cluster (A
till E) the treatment suggestion must be stored.

Move the cursor one position to the right by means of the
"Display parameter selectors" [4].

Select by means of the "Central control" [8] the program number
under which the settings must be stored. The display shows the
already "old" stored settings under that number.

Operate the "Accept key" [7]

In the display appears "Overwrite ?" Select by means of the
"Central control" [8] "Yes" if you wish to continue with the
procedure or "No" if you wish to cancel the procedure.

Operate the "Accept key" [7] once again. Two short beeps
indicates that the treatment suggestions are stored into the
memory.
To retrieve a treatment suggestion from the memory (program 1 till 30)

Operate "Program retrieve key" [1]. In the upper right corner
a number flashes (e.g. #1).

Select by means of the "Central control" [8] the desired
program number. Will looking for the right program the
display shows the parameter settings of the passing
programs.

Operate the "Accept key" [7] as soon as you have selected
the right program number.

Set the power (if a treatment time was programmed the
cursor is automatically set on the power position).
Treatment starts as soon as the power is adjusted.
To retrieve a treatment suggestion from the protocol memory
Two possibilities are available to retrieve a treatment suggestion from the protocol memory:
1. To retrieve by name: On the display the clusters and indications are displayed in word.
081-400-095-4A_950+_EN
ENGLISH
Page 18 of 26