Checchi & Magli WOLF PRO Bedienungs- Und Wartungsanleitung Seite 65

Check of nuts and bolts tightening torque
Check that the main fixing nuts and bolts are tight.
If the bolts are loose tighten them to the prescribed
Cleaning the work vehicle
Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
Troubleshooting
The following list contains a number of common problems that may arise during work, together with the ways to
solve them.
Problem
The seedling planted is too close
to the surface or too deep
The hole made by the drilling cup
in the ground and/or the plastic
mulch is too big
The soil has not been properly
compacted on top of the seedlings
The plastic mulch is being dam-
aged
The seedling overturns onto the
ground or is not planted
English language
MAINTENANCE INFORMATION
torque (see the "Nuts and bolts tightening torques
chart").
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication diagram").
Likely cause
Incorrect planting depth
The cam is in the wrong position
Incorrect planting depth
Packing wheels not set correctly
Incorrect load on packing wheels
Packing wheels not set correctly
Protection skid not set properly
Incorrect load on packing wheels
Packing wheels not set correctly
Incorrect planting depth
Incorrect load on packing wheels
27
Solution
Make the relative adjustment (see "Ad-
justing the planting depth")
Adjust (see "Cup opening adjustment")
Make the relative adjustment (see "Ad-
justing the planting depth")
Adjust the packing wheels (see
"Adjusting the packing efficiency")
Adjust (see "Adjusting the planting
force (load applied to ground)")
Adjust the packing wheels (see
"Adjusting the packing efficiency")
Adjust (see "Adjusting the protection
skid")
Adjust (see "Adjusting the planting
force (load applied to ground)")
Adjust the packing wheels (see
"Adjusting the packing efficiency")
Make the relative adjustment (see "Ad-
justing the planting depth")
Adjust (see "Adjusting the planting
force (load applied to ground)")
7
Use and maintenance