Checchi & Magli WOLF PRO Bedienungs- Und Wartungsanleitung Seite 56

Adjusting the row spacing
A
B
A
UN41 0808ER
WARNING
Secure the work vehicle in position (lifted off the
ground) with external means (trestles, etc.).
Do not stand under the hoisted machine unless it is
suitably secured in position.
Adjust the gap between the planting units to obtain
the row spacing required (for distances envisaged, see
"Technical characteristics" for model concerned).
Proceed as outlined below.
1) Lift the work vehicle slightly off the ground.
2) Loosen the nuts (A).
3) Slide the planting unit along the frame (B) until the
required plating spacing is obtained.
4) Tighten the nuts (A).
Cup opening adjustment
Adjust the cup opening according to the size of the
seedling.
The numbering on the plate (C) shows the six different
cup opening options.
The cam in position "1" means maximum opening.
The cam in position "6" means minimum opening.
The cam position is shown by the hole which can be
seen via the slot in the plate (C) in correspondence with
the number.
English language
ADJUSTMENT INFORMATION
C
A
C C C
Planting in
bare ground
- To plant the seedlings in bare ground, adjust the
planting units so that the seedlings are kept "C" cm
10 - 12 away from tractor wheel.
- To plant the seedlings under plastic mulch, adjust
the planting units so that the seedlings are kept a
distance "D" of cm 15 away from the soil ridging the
sides of the plastic mulch (E).
- The manufacturer recommends you position the
work vehicle's wheels aligned with the tractor's
wheels.
The table shows the standard position of the cams based
on the cup type.
Cup type
Standard cup
Long cup
6 x 6 cup
8 x 8 cup
18
5
D D
Planting through
plastic mulch
Standard cam position
1
4
4
4
Use and maintenance