Checchi & Magli DUAL 12 GOLD Bedienungs- Und Wartungsanleitung Seite 78

Seat positioning
Poor work posture will tire the operator and could lead
to mistakes being made; therefore, before starting work,
adjust the seat and secure it in the position that offers
maximum comfort.
Proceed as outlined below.
1) Loosen the screws (A) and adjust the seat height.
2) Tighten the screws (A) to secure the seat in the right
position.
3) Loosen the nut (B) to move the seat lengthways in
relation to the vehicle.
4) Tighten the nut (B) to secure the seat in the right po-
sition.
Changing the transmission ratio (Rapid Shift)
WARNING
Switch off the tractor engine, remove the ignition
key, and store in a safe place to prevent an accident
during the change of the transmission ratio.
B
UN41-0503MM
To change the transmission ratio proceed as outlined.
1) Unscrew the knob (A).
2) Remove the casing (B).
3) Loosen the knob (C).
4) Push lever (D) to slacken the chain.
5) Move the chain (E) on the pair of pinions correspond-
English language
INFORMATION FOR USE
A
UN41-0151DH
WARNING
The aim of the change of the transmission ratio is to
obtain the required plant spacing.
See the "Adjusting the plant spacing" chapter to se-
lect the pair of pinions to be used from the range of
possible combinations.
C
ing to the plant spacing necessary to plant the seed-
ling.
6) Pull the lever (D) and tighten the chain adequately.
7) Tighten the knob (C).
8) Fit the casing (B).
9) Tighten the knob (A).
30
B
A
E
D
Use and maintenance
6