Checchi & Magli DUAL 12 GOLD Bedienungs- Und Wartungsanleitung Seite 73

Adjusting the dispensing/ejection timing
When the plant falls into the ploughshare (A), the ejector
(B) should be in the rear position and should then start
pushing the plant to eject it.
B
UN41-0554BN
Proceed as outlined below.
1) Remove the pin (C).
2) Remove the lid (D).
3) Loosen the screws (E).
4) Turn the dispenser clockwise to speed up the ejec-
tor's pushing action or rotate the dispenser anticlock-
wise to delay the pushing action.
5) Tighten the screws (E).
English language
ADJUSTMENT INFORMATION
A
Adjust the correct phase between the dispensing unit
and the ejector according to the different planting
speeds.
6) Place the lid (D) on the dispensing unit.
7) Insert the plug (C).
Rotating the distributor also corrects the cup opening
with respect to the drop tube.
If the distributor is not rotated enough to align the cup
opening with the drop tube, adjust the position of the
cams (see "Adjusting the cup opening stage").
25
5
D C
E
Use and maintenance