Airwell WELLEA MONOBLOC DF A R32 Installationsanleitung Seite 57

The AUTO RESTART function reapplies the user interface
settings at the time of the power supply failure. If this function
is disabled, when power returns after a power supply failure,
the unit won't auto restart.
10.7.14 POWER INPUT LIMITATION
How to set the POWER INPUT LIMITATION
Go to MENU> FOR SERVICEMAN>
14.POWER INPUT LIMITATION
14 POWER INPUT LIMITATION
14.1 POWER INPUT LIMITATION
ADJUST
10.7.15 INPUT DEFINE
How to set the INPUT DEFINE
Go to MENU> FOR SERVICEMAN> 15.INPUT DEFINE
15 INPUT DEFINE
15.1 ON/OFF(M1M2)
15.2 SMART GRID
15.3 T1B(Tw2)
15.4 Tbt1
15.5 Tbt2
ADJUST
15 INPUT DEFINE
15.6 Ta
15.7 SOLAR INPUT
15.8 F-PIPE LENGTH
15.9 dTbt2
15.10 RT/Ta_PCB
ADJUST
10.7.16 CASCADE SET
How to set the CASCADE SET
Go to MENU> FOR SERVICEMAN>16. CASCADE SET
16 CASCADE SET
16.1 PER_START
16.2 TIME_ADJUST
16.3 ADDRESS RESET
ADJUST
After setting the address, you need to press the "UNLOCK" key
to confirm.
The address "FF" is an invalid address code.
10.7.17 HMI ADDRESS SET
How to set the HMI ADDRESS SET
Go to MENU> FOR SERVICEMAN> 17.HMI ADDRESS SET
0
When HMI SET is set to SLAVE, the controller can only switch
the operation mode, turn on or off, set the temperate, and
cannot set other paramters and functions.
The address "FF" is an invalid address code.
REMOTE
NO
NO
NO
HMI
HMI
NON
＜10m
12°C
NON
20%
5 MIN
FF
53
17 HMI ADDRESS SET
HMI SET
HMI ADDRESS FOR BMS
ADJUST
MASTER
0