Safety Instructions - SATA paint set 10 Betriebsanleitung

Operating Instructions SATA FDG
ments
DIN 31000:2011
"General principles for the safe design of products."

2. Safety Instructions

Always read and heed all instructions given below. Failure to comply or
incorrect compliance can result in malfunctions or cause injuries.
2.1. Requirements regarding personnel
The material pressure tank may only be used by experienced skilled
workers and instructed persons who have thoroughly read and under-
stood these operating instructions. People whose reactions have been
adversely affected by drugs, alcohol, medication or by any other means
are prohibited from handling the material pressure tank.
2.2. Personal Protection Equipment
Always use approved breathing and eye protection, suitable protective
gloves, workwear and safety boots when using the material pressure tank
and during cleaning and maintenance work.
2.3. Use in explosive atmospheres
The material pressure tank is approved for use / storage in potentially ex-
plosive atmospheres of ex-zone 1 and 2. Heed the product ID.
2.4. Safety Instructions
Installation site
■ For installation in explosive atmospheres, prior to initial commissioning
the material pressure tank must be inspected in accordance with the
Industrial Safety Regulations by a qualified specialist having adequate
knowledge of the ATEX Directive.
■ Never use the material pressure tank in the vicinity of electrical equip-
ment that is not explosion-proof.
■ Keep the material pressure tank away from ignition sources such as
naked flames, burning cigarettes or flying sparks.
■ Working areas where dangerous substances are processed or stored
must be adequately ventilated. In the event of ventilation failure, the
work must be stopped immediately and any agitators must be switched
off.
Technical status
■ Never start using the material pressure tank when damaged or when
EN
165