Emptying The Condensate Container; Cleaning The Lint Trap - hanseatic HWT8A3GT Gebrauchsanleitung

Emptying the condensate
container
The condensate container (9) must be emp-
tied after every use . If the condensate con-
tainer is full, the cycle will stop and the symbol
will appear . After emptying the condensate
container, you can press the Start/Pause
button (2) to resume the cycle .
1 . Use both hands to pull out the conden-
sate container .
2 . Pour the condensate into a basin .
3 . Slide the condensate container back into
the dryer .
Cleaning and maintenance

Cleaning the lint trap

The dryer is equipped with a lint trap (8) for
the door . This trap must be cleaned after
every use .
1 . Switch off the dryer .
(9)
2 . Open the door .
3 . Remove the lint trap .
4 . Open the lint trap and remove the accu-
5 . Dry the lint trap thoroughly afterwards .
6 . Insert the lint trap back into the appliance .
(8)
mulated lint .
You can also clean the lint trap under run-
ning water .
Ensure that the lint trap is inserted in the
correct position .
Page EN-21