Cleaning And Maintenance; General Cleaning; Brew Group Cleaning - Profitec Pro 300 Bedienungsanleitung

Important
After every application, clean the steam nozzle and the steam dispenser with a non-
abrasive, damp cloth. This removes possible liquid residues.
Please close the hotwater-/steam valve gently and do not over tighten it.
Risk of injury
Avoid skin contact with the steam dispenser while cleaning!
7

CLEANING AND MAINTENANCE

A regular and thorough care is very important for the performance, the longevity and the safety of your
machine.
Caution!
Always switch off the machine (power switch in lower position), disconnect the power cord
and let the machine cool down to room temperature (for at least 30 minutes) before cleaning.
Never submerse the machine in water; do not operate the machine with wet hands. There is
a risk of electric shock

7.1 General cleaning

Daily cleaning:
Portafilters, filters, water tank, drip tray, drip plate of the drip tray and tamper require daily cleaning. Clean
with warm water and/or with a food safe detergent.
Please note, the portafilter, drip tray and water tank are not suitable for the dish washer.
Clean the shower screen and the group gasket in the lower part of the group and remove visible deposits
without dissasembling the parts.
Cleaning as necessary:
Clean the steam and hot water wands after every use.
Clean the body when the machine is switched off and cold.
We suggest that you empty the water from the steam-/hot water boiler every 1 to 2 weeks. This makes
sure that there is always fresh water in the steam-/hot water boiler.
Empty the water drip tray regularly and do not wait until it is full.
Use a soft, damp cloth for cleaning.
Never use abrasive or chloric detergents!

7.2 Brew group cleaning

A brew group cleaner in tablet form is available at your specialised dealer. With this detergent, you can
clean and degrease the group very easily. The cleaning is carried out using the blind filter included with
delivery. The group cleaning should be carried out after about 150 cups brewed.
Follow the instructions as noted below:
1 Heat up the coffee boiler.
2 Place the blind filter into the portafilter.
3 Put a cleaning tablet into the portafilter.
4 Clamp the portafilter into the brew group.
5 Operate the coffee switch. The blind filter will fill with water.
6 Turn the coffee switch on and off in intervals of 20 seconds. Stop once clear water comes out of the
drainage cylinder.
7 Unclamp the portafilter with the blind filter, rinse it with fresh water and replace it.
8 Once more operate the coffee switch in intervals of 20 seconds for 1 minute.
9 Unclamp the portafilter with the blind filter, rinse it with fresh water and re-insert the coffee filter. The
brew group is now ready for use again.
Translation of the original German user manual
ENGLISH
25