Storage; Care And Maintenance; General Notes; Cleaning The Device - Kärcher KM 85/50 W Bp Originalbetriebsanleitung

6. When transporting in vehicles, secure the device against slip-
ping and tipping over according to the applicable guidelines.

Storage

WARNING
Risk of injury and damage
Note the weight of the device.
1. Place the device in a dry, protected place on an even surface.
2. Remove the key from the key-operated switch.
3. Clean the vehicle inside and out.
4. Pull off the outer battery connector.
5. Recharge the battery every 2 months.

Care and maintenance

General notes

DANGER
Risk of accidents and injuries due to unintentional move-
ment of the device
Switch off the device and remove the key from the key-operated
switch before carrying out any care and maintenance work.
Disconnect the central battery plug connector.
Note
● Adhere to the safety instructions for care and maintenance.

Cleaning the device

CAUTION
Risk of short circuits due to water stream
Do not clean the device with a hose or high-pressure water jet.
DANGER
Health risk from dust
Wear a dust mask and safety goggles when cleaning with com-
pressed air.
ATTENTION
Risk of damage to the surfaces
Do not use any scouring agents or aggressive cleaning agents for
cleaning purposes.
1. Blow out the inside of the device with compressed air.
2. Clean the inside and outside of the device with a damp cloth,
soaked in mild washing lye.

Maintenance intervals

Maintenance by the customer
Note
All servicing and maintenance work must be performed by a qual-
ified specialist. If necessary, you can consult a Kärcher specialist
dealer at any time.
● Daily maintenance
1 Check the roller brush and side brush for any tangled pieces
of tape.
2 Check that the control elements are fully functional.
3 Dedust the dust filter.
● Weekly maintenance
1 Check the moving parts to make sure that they move smooth-
ly.
2 Check the sealing strips in the sweeping area for correct ad-
justment and for wear.
3 Check the roller brush and side brush for wear.
4 Check the dust filter and clean the filter box as necessary.
5 Check the tension of belts, check for wear and check that they
are functional.
● Maintenance after wear
1 Adjust or change sealing strips.
2 Replace the roller brush.
3 Replace the side brush.
4 Change brake pads.
Note
See chapter "Maintenance work" for descriptions.
24
Maintenance by Customer Service
Note
To ensure the validity of warranty claims, all servicing and main-
tenance work during the warranty period must be performed by
an authorised Customer Service department.
1 Have maintenance work carried out according to the inspec-
tion checklist.
Checking the roller brush for entangled pieces of tape
1. Check the roller brush and side brush for any tangled pieces
of tape.
a The inspection can be made with the waste containers re-
moved.
b For safety reasons, tangled pieces of tape must only be re-
moved when removed.
Replacing / inspecting the roller brush
Removing the roller brush
Roller brush
1
Bearing plate
2
Knurled screws
3
Cover plate
4
1. Switch off the device and remove the key from the key-operat-
ed switch.
2. Lower the roller brush.
3. Unscrew the knurled screws.
4. Remove the bearing plate and cover plate.
5. Pull out the roller brush.
Installing the roller brush
Figure: Installation position seen from the rear (with the waste
container removed)
1. Be sure to install the roller brush in the correct installation po-
sition (the roller brush mounts are identical).
2. Install the cover plate and bearing plate in reverse order.
English

Maintenance work