Start Up; Operation; Shutdown; Transport - Kärcher KM 70/30 C Bp Originalbetriebsanleitung

Open the battery compartment, stove
–
the cable with the plug next to the bat-
tery, replace the lid of the battery com-
partment and lock it in.
Bp model:
 Switch off the charger and remove the
plug from the socket.
 Hang out the charging cable out of the
machine.
 Close the cover of the battery compart-
ment.
Maximum battery dimensions
Length Width
175 mm 166 mm
Removing the batteries
 Remove the lid of the battery compart-
ment.
 Turn out the screw and remove the bat-
tery cover.
 Clamp off the minus pole of the battery.
 Disconnect pole terminal to positive
pole (-).
 Remove the battery.
 Dispose of the used battery according
to the local provisions.

Start up

Adjust the pushing handle
Figure 3, see cover page
 Loosen both the star grips.
 Pull the pushing handle backward and
tilt it to the desired position.
 Press the pushing handle forward and
lock it in.
 Tighten the star handles.

Operation

Programme selection
Figure 4, see cover page
1 OFF - Appliance is switched off.
2 Sweep.
3 Sweep suction (only Adv. model).
Sweeping mode
Caution
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
The drive belts of the side brushes can slip
down. Tilt up the side brushes only when
the appliance is switched off.
Note
To achieve an optimum cleaning result, the
driving speed should be adjusted to take
specific situations into account.
Note
During operation, the waste container
should be emptied at regular intervals.
Note
Also lower side brush when cleaning along
edges.
 Tilt the side brushed upward or down-
ward depending on the task.
10
Note
The dust blown up by the side brushes is
not sucked in. Place the side brushes at the
edge only while sweeping.
 Set the programme switch to sweep or
sweep suction.
Height
125 mm
Dry floor
Wet floor
 Move the appliance over the surface to
be swept.
Adjust the brush contact pressure
Figure 5, see cover page
 Lift, adjust and lower the lever for the
contact pressure of the sweeping roller.
+ Increase contact pressure.
– Reduce contact pressure.
 Adjust the pressure by turning the turn-
ing handle for the contact pressure of
the side brushes.
+ Increase contact pressure.
– Reduce contact pressure.
Note
A very high contact pressure means in-
creased power consumption and hence
lesser usage time.
Collect dirt
Figure 6, see cover page
 Slightly press the pushing handle
downward so that the appliance lifts up
slightly towards the front.
 Move the appliance with the raised up-
per part over the dirt.
 Now lower the appliance again.
The battery display shows the charging sta-
tus of the battery during operations:
Emptying waste container
Warning
Risk of injury on account of rotating roller
brush.
Before removing the waste container
please turn the programme selection to
"OFF" and wait until the roller brush comes
to a halt.
Sweep Sweep suc-
tion
Sweep Sweep
Battery display
full glows green
30% capacity re- glows yel-
maining low
10% capacity re- blinks red
maining
Protection against glows red
total discharge; the
appliance is
switched off
3
-
EN
Note
Dust progress. As far as possible, shake off
the filter and empty the waste container in
open places.
 Turn the program selection switch to
"OFF".
 Only Adv. model: Pull the handle of the
filter shake-off many times and releaes
it.
 Only Adv. model: Tilt the dust suction
upward.
 Pull the waste container upward at the
handle and remove it from the appli-
ance.
Figure 7, see cover page
 Dispose off the waste according to local
regulations.

Shutdown

If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
 Park the sweeper on an even surface.
 Lock the sweeper to ensure that it does
not roll off.
 Clean the inside and outside of the
sweeper.
 Park the machine in a safe and dry
place.
 Disconnect battery.
 Charge battery and recharge it approx.
every 2 months.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Turn the program selection switch to
"OFF".
 Lift the appliance at the carrying han-
dles when you want to transport it.
 Secure the wheels of the machine with
wheel chocks.
 Secure the machine with tensioning
straps or cables.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

Danger
Risk of injury. Before performing any tasks
at the machine, first turn the programme
selection switch to "OFF"and clamp the ca-
ble at the minus pole of the battery.