Sweeping Mode; Emptying Waste Container En; Turn Off The Appliance; Transport - Kärcher KM 130/300 R Bp Betriebsanleitung

Sweeping mode

Caution
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
Note: To achieve an optimum cleaning re-
sult, the driving speed should be adjusted
to take specific situations into account.
Note: During operation, the dust filter
should be shaken off and cleaned at regu-
lar intervals.
Sweeping dry floors
 Switch on the blower.
 Set the programme switch to sweep
with sweeping brush when cleaning
surfaces.
 Set the programme switch to sweep
with sweeping brush and side brush
when cleaning edges.
Sweeping damp or wet floors
 Switch off the blower.
 Set the programme switch to sweep
with sweeping brush when cleaning
surfaces.
 Set the programme switch to sweep
with sweeping brush and side brush
when cleaning edges.
Emptying waste container
Danger
Risk of injury! When emptying the waste
container, care should be taken to ensure
that no persons or animals are within its
swivelling range.
Danger
Danger of crushing. Never reach into the
rod assembly for the drainage mechanism.
Stay away from the area under the raised
container.
Danger
Danger of tipping. Place the machine on an
even surface during emptying.
 Set programme selection switch to
"Transport drive". .
 Raise waste container.
 Slowly drive towards the collection con-
tainer.
 Lock parking brake.
 Open the container door: Press the left
side of the switch and empty the waste
container.
 Close the container door: Press the
right side of the switch (approximately 2
seconds), until the unit is tilted to the
end position.
 Release parking brake.
 Drive away the collection container
slowly.
 Lower the waste container up to the
end-position.

Turn off the appliance

 Press brake pedal and keep it de-
pressed.
 Lock parking brake.
 Turn ignition key to "0" and remove it.
6
-
EN

Transport

Danger
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Turn ignition key to "0" and remove it.
 Lock parking brake.
 Secure the appliance at the lashing
points (4x) using tension belts, ropes or
chains.
 Secure the wheels of the machine with
wheel chocks.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

Danger
Risk of injury and damage! Note the weight
of the appliance in case of storage.

Shutdown

If the sweeper is going to be out of service
for a longer time period, observe the follow-
ing points:
 Park the sweeper on an even surface.
 Set programme selection switch to
"Transport drive". .
 Turn ignition key to "0" and remove it.
 Lock the sweeper to ensure that it does
not roll off.
 Clean the inside and outside of the
sweeper.
 Park the machine in a safe and dry
place.
 Remove the battery plug from machine.
 Charge battery and recharge it approx.
every 2 months.
19