Fuses; Fuses In The Cab; Fuses On The Vehicle; Storage - Kärcher MC 250 Handbuch

14.9 Fuses

14.9.1Fuses in the cab

The fuses in the driver's cab are located behind a cover on
the middle rear wall of the cab.
Cover
1
Locks
2
Fuses
3
Diagnostic connector
4
1. Fold the passenger seat backrest forward.
2. Open the cover latches then tilt the cover and remove it
upwards.
3. Replace defective fuses.
Note
Use only fuses with the same ampere rating.

14.9.2Fuses on the vehicle

The next fuses are located on the vehicle behind a cover
on the right side panel.
66
Right side panel
1
Cover
2
Fuses
3
1. Release the side panel lock with a square wrench.
2. Tilt the panel outwards, a safety rope holds it in position.
3. Open the cover latch and remove the cover.
4. Replace defective fuses.
Note
Use only fuses with the same ampere rating.
15

Storage

WARNING
Risk of injury and damage
Be aware of the weight of the vehicle.
1. Park the vehicle in a protected, level and dry place.
2. If there is a danger of frost, check that there is enough
antifreeze in the coolant.
3. Clean the vehicle inside and out.
When stored for more than one month:
4. Jack up the vehicle (freely rotating wheels).
5. Disconnect the battery, recharge every 2 months.
6. When restarting after prolonged storage, carry out
scheduled maintenance as necessary.
English