Safety Devices; Safety And Information Signs; Standard Accessories - Angelo Po 1G1PI1E Bedien- Und Installationshandbuch

Although the appliance is complete with all safety
devices, during installation and connection addi-
tional devices must be added if necessary to com-
ply with the relevant legal requirements.
A)Safety thermostat; cuts off the electricity supply
in case of overheating.
B)Safety valve.
Caution - warning
Make a daily check that the safety devices are
properly installed and in good working order.
The illustration shows the position of the signs pro-
vided.
A)Nameplate with manufacturer and appliance
data
B)General hazard: read the manual carefully
before carrying out any procedure.
C)General hazard: when washing the appli-
ance do not point pressurised water jets at
internal parts.
D)General hazard: all relevant regulations
must be complied with. "Install in compliance with
the relevant regulations and use in well ventilated
premises only".
IT
E)General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of
failure to comply with the installation and com-
GB
missioning instructions".
F) Burn hazard: watch out for hot surfaces.
DE
G)CE marking: this indicates that the equipment is
compliant with all relevant laws applicable to the
FR
product.
H)Arm crushing hazard: never insert hands in the
ES
pan while in use.
L) Scald hazard: take care, very hot steam.
M)General hazard: dry operation is forbidden.
Comes complete with the following:
– food-approved grease (KLUBER PARALIQ GTE
703WO).
English

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

STANDARD ACCESSORIES

IDM-39603601800.tif
D
E
C B
A
G
N)General warning: describes the specifications of
the jacket.
P)General warning: describes the precautions to
be adopted during use.
Q)WEEE symbol: indicates that the appliance is
subject to specific waste disposal regulations.
- 4 -
A
B
M L N
Q P
IDM-39616400400.tif
F
H