Introduction And Safety; Electrical Installation; Input And Output Connections - Xylem LOWARA Aquavar IPC Schnellstartanleitung

en - Original instructions
Menu personale
25.11
25.12
25.13
25.14
25.15
25.16
25.17
25.18
25.19

1 Introduction and Safety

1.1 Purpose of the manual
Purpose of this manual
The purpose of this manual is to provide necessary information for quick start up. Please read the full manual
for information about:
• Installation
• Operation
• Maintenance
CAUTION:
Read this manual carefully before installing and using the product. Improper use of the product
can cause personal injury and damage to property, and may void the warranty.
NOTICE:
Save this manual for future reference, and keep it readily available at the location of the unit.
1.2 Safety
WARNING:
• The operator must be aware of safety precautions to prevent physical injury.
• Operating, installing, or maintaining the unit in any way that is not covered in this manual
could cause death, serious personal injury, or damage to the equipment. This includes any
modification to the equipment or use of parts not provided by Xylem. If there is a question
regarding the intended use of the equipment, please contact a Xylem representative before
proceeding.
• Do not change the service application without the approval of an authorized Xylem represen-
tative.
WARNING:
This Guide does not replace the Installation, Operation and Maintenance Manual. The qualified
personnel must make sure to have read and understood the Installation, Operation and Mainte-
nance Manual before installing the product and putting it to use.

2 Electrical Installation

2.1 Input and output connections

20
Numero parametro
19-63
20-12
20-14
22-20
19-20
19-21
22-50
22-51
22-52
Valore predefinito
40%
bar
300
Off
Disabilitato
10 s
Off
30
20%
Nome parametro
Percentuale disattivazione
Unità riferimento/Retro-
azione
Riferimento max./retroaz.
Setup auto. bassa poten-
za
Mancanza Acqua/Perdita
Adescamento(NWLP)
Ritardo Mancanza
Acqua/P. Ad.
Funzione fine curva
Ritardo fine curva
End of Curve Tolerance