Werbung
Champion
Troubleshooting
Problem
The juice is
expelled along
with the pulp
The motor feels
warm
Juice leaks out
from between
the nylon parts.
The Champion
parts are stained
and smudged
The motor does
not run
Downloaded from
www.Manualslib.com
Juicer – The Classic Juicer
®
Possible Reason
Have you properly
installed the screen?
Is the screen
clogged?
The motor has only
been painted and
is not insulated, so
that it is normal that
you feel warmth.
It leaks a little bit.
It leaks a lot:
The nylon parts
are warped from
improper use or
from having been
washed too hot.
The stains are
caused by red and
green vegetables.
Are all parts
assembled correctly,
as described on
page 34?
manuals search engine
Solution
Examine the position of the screen, following the
instructions on page 34. If necessary, insert the screen
again, and carefully follow the instructions on page 34.
If the holes in the screen are clogged, soak it for 24-48
hours in a strong solution of cold water and washing-up
liquid. Then brush it again. The screen should be cleaned
after every use.
If this does not help, we recommend soaking the screen
in pure olive oil over night.
Otherwise, order a new screen.
As long as you can touch the motor, there is no reason
to worry.
No need to worry. This is normal and has to do with the
moisture of the food being processed.
Contact your importer (see page 2, Importer and Service
Centre).
The quality of the juice is not affected. You can, however,
intensively clean the parts occasionally. To do so, use
butter, margarine, or oil to remove the vegetable stains.
You should then soak the parts in cold water and lots of
washing-up liquid for at least 5 hours.
For your safety, the motor only runs when the juice outlet
unit is pushed all the way to the back.
39
Werbung
Kapitel
Fehlerbehebung
