Fitting The Printer Tray - Konig + Neurath DO IT 4 Montageanleitung

7.
Fitting the printer
tray
Fit tubes (a) to the printer shelf
from beneath with screws
ø6,3x12, make sure that the
distance between shelf and
tubes is 5 mm.
(a)
Note dimension of the pins (b):
40 mm (T profile) or 30 mm
(rectangular profile)
Push the pins of the printer tray
(c) into the appropriate open-
Distance 5 mm
ings on the cross-beam from
underneath and screw into
place from inside using button
head screws (d) M6x35, T-
(b)
profile or M6x16, rectangular
profile (SW4).
rectangular
T profile
Optional: fit support leg (e) to
profile
the printer shelf from beneath
with chip-board screws ø5x15.
40
30
(d)
(c)
(e)
23