Fitting The Fly-By Screen; Fitting The Desk Screen (In 3Rd-Level And Clamp Adapters) - Konig + Neurath TABLE.T Montageanleitung

16.
Fitting the fly-by
screen
Remove end caps (a).
Insert retaining plate (b) of
fly-by screen into frame
bracket and fix them by using
cylinder head screws (c)
M6x10 (SW5) on each side.
17.
Fitting the desk
screen (in 3rd-level
and clamp adapters)
Remove cover (a) and snap
off the central part.
Attach cover (b) and insert
clamp adapter (c) into the
desk adapter, tighten grub
screw (d) (SW3).
Insert the screen (e) into the
clamp adapter and align
laterally. Tighten counter-
sunk screw (f) M6x16 (SW4)
on rear of adapter.
Slide clamp adapter (g) onto
desk top, insert screen into
adapter, tighten counter-sunk
screw (h) M6x16 on rear of
adapter and tighten clamp
bolt (i) under desk top (SW4).
(a)
(b)
snap off
(a)
(e)
(f)
38
(b)
inside
(c)
(c)
(b)
(d)
(g)
(h)
(i)