Motor Battery Installation; Canopy Assembly - E-FLITE PLATINUM-Serie Bedienungsanleitung

EN
 7. Route the lead for the retracts through the fuselage. Routing it
through the tray the nose gear is mounted to and along the bottom of the
fuselage will keep the installation clean. Secure any loose leads with tie
wraps (not included).
Use a #1 Phillips screwdriver to remove the nose gear cover so there
is better access for routing the retract leads. Replace after routing the
leads.

Motor Battery InstallatIon

Required Parts
Fuselage assembly
Motor battery
Fan cover
Required Tools and Adhesives
Scissors
 1. Apply the hook and loop tape to the bottom of the battery. This will keep
the battery from sliding in the fuselage which could change the center of
gravity.
 2. Apply the mating hook and loop tape to the battery tray in the
fuselage.
48
Downloaded from www.Manualslib.com
E-tips
Hook and loop tape
Hook and loop strap
Phillips screwdriver: #1
manuals search engine
 3. Secure the battery in the fuselage using the hook and loop strap.
Make sure the strap is not pinching any of the servo leads on the bottom
side of the battery tray.

canoPy asseMBly

Required Parts
Canopy Cockpit interior
Required Tools and Adhesives
Hobby scissors
 1. Locate the cockpit interior and use hobby scissors to trim the interior
along the inscribed line. Trim the interior a little outside the line so it can
be trimmed to fit to the canopy.
 2. Place the interior in the canopy. It may be necessary to bend the
interior slightly to fit past the canopy frame.
Pilot (optional) (PKZ4414)
Clear tape