Main Landing Gear Installation - Retractable Gear - E-FLITE PLATINUM-Serie Bedienungsanleitung

EN
The end of the axles may have a slight bur on them from the factory. If
the wheel is hard to install use a file to remove this bur.
Always use threadlock on metal-to-metal fasteners to prevent them from
vibrating loose.
 12. Slide a 3.5mm aluminum wheel spacer on the axle, then the
wheel with adapters. A 3.5mm wheel collar is used to secure the wheel
in position by tightening the setscrews onto the axle using a 1.5mm hex
wrench.
 13. Repeat steps 1 through 12 to install the remaining main landing
gear and wheel.
20
Downloaded from www.Manualslib.com
E-tips
manuals search engine
MaIn landIng gear InstallatIon -
retractaBle gear
Required Parts
Transmitter
Receiver battery
Servo extension, 3-inch (76mm) (2) Aluminum wheel collar with
Aluminum wheel spacer, 3.5mm
(2)
Wheel axle adapter set (2)
Main landing gear retract (2)
Required Tools and Adhesives
Drill
Threadlock
Thin CA
String
Trim seal tool
 1. Use a hobby knife with a new #11 blade to remove the covering for
the retract mechanism and landing gear assembly. Leave 1/32-inch (1mm)
of covering around the inside edges. Use a trim seal tool to iron down the
covering around the edges to finish the opening.
 2. Use a 1.5mm hex wrench to remove the strut from the retract
mechanism.
Receiver
Wing panel assembly (right and
left)
setscrew, 3.5mm (2)
Wheel, 1 / -inch (44.5mm) (2)
3
4
Main landing gear strut (right and
left)
3mm x 14mm countersunk self-
tapping screw (8)
Drill bit: 5/64-inch (2mm)
Hex wrench: 1.5mm
Phillips screwdriver: #1
Scissors
Hobby knife with #11 blade