Wing Spar Installation - E-FLITE PLATINUM-Serie Bedienungsanleitung

 21. Repeat steps 3 through 18 to install the remaining flap servo and
assemble the flap linkage. Connect the flap linkage to the flap control horn
ONLY at this time.
 22. Set the flap switch to the UP flap position. Connect the linkage to
the flap servo and adjust its length until the flap is aligned with the aileron.
This will be the UP flap position.
You may have to fine-tune both flap linkages up or down so they align
at all three positions: up, middle, and down. It is very important to use
servo arms positioned at the same angle on the splines of the servo so
the travel will match in all positions.
Downloaded from www.Manualslib.com
E-tips
manuals search engine

WIng sPar InstallatIon

Required Parts
Fuselage
8-32 x 1/4-inch socket head screw
(4)
Required Tools and Adhesives
Low-tack tape
15-minute epoxy
Paper towels
Epoxy brush
Ruler
Petroleum jelly
Ball driver: 9/64-inch
 1. Use a #1 Phillips screwdriver to remove the four 2mm x 8mm
screws that hold the fan cover to the fuselage. Set the screws and cover
aside in a safe location.
 2. Slide the canopy hatch pin rearward and lift the canopy from the
fuselage. The canopy is held in place with two pins at the front. Set the
canopy aside so it doesn't get damaged.
Carbon wing spar (2)
Wing panel assembly (right and
left)
Phillips screwdriver: #1
Mixing cup
Mixing stick
Rubbing alcohol
Medium grit sandpaper
Felt-tipped pen
EN
15