6-Channel Receiver Installation - E-FLITE PLATINUM-Serie Bedienungsanleitung

6-channel receIver InstallatIon

Required Parts
Fuselage assembly
6-inch (152mm) Y-harness (2)
(flaps, ailerons)
3-inch (76mm) servo extension
(flaps)
9-inch (228mm) servo extension
(retracts)
Required Tools and Adhesives
Scissors
NOTE: The following section is for installing the receiver in the Habu 32 for
a 5- or 6-channel operation depending on if you are using retracts or not.
This is the basic setup for the Habu 32 using Y-harnesses for all control
surfaces.
 1. Prepare the aileron harness by securing a 12-inch (304mm)
extension to a 6-inch (152mm) Y-harness using string or a commercially
available connector. The 12-inch (304mm) extension will plug into the
aileron channel of the receiver.
 2. Prepare the flap harness by securing a 12-inch (304mm) extension
to a 6-inch (152mm) Y-harness using string or a commercially available
connector. The 12-inch (304mm) extension will plug into the aileron
channel of the receiver. Secure a 3-inch (76mm) extension to one side of
the Y-harness using string or a commercially available connector. Make
sure to mark the flap harness so it can be easily identified from outside
the fuselage when installing the wing panels.
Downloaded from www.Manualslib.com
Harness from retract assembly
3-inch (76mm) Y-harness
(steering/rudder)
6-inch (152mm) servo extension
(retracts)
12-inch (304mm) servo extension
(2) (flaps, ailerons)
String
manuals search engine
 3. Insert the flap and aileron harnesses through the hole in front of the
elevator servo and into the fuselage. The leads will exit toward the top of
the fuselage above the intake. Secure the leads using tape or tie-wraps to
keep them from interfering with the operation of the elevator servos.
 4. (Optional Retracts) Prepare the retract harness by securing a 6-inch
(152mm) and 9-inch (228mm) extension to the retract harness using
string or a commercially available connector. This will plug into the retract
channel of the receiver.
 5. Plug the leads for the elevator, ailerons, flaps, and speed control
into the receiver at this time. Plug a Y-harness into the rudder channel of
the receiver for the rudder and steering. All the extensions should now be
connected to the receiver. Use the following to connect the extensions to
the receiver:
EN
45