Rudder Servo Installation - E-FLITE PLATINUM-Serie Bedienungsanleitung

 17. Slide a 3.5mm aluminum wheel spacer on the axle, then the
wheel with adapters. A 3.5mm wheel collar is used to secure the wheel
in position by tightening the setscrews onto the axle using a 1.5mm hex
wrench.
 18. Check the operation of the nose gear retract using the radio
system. The nose gear door is precut to fit from the factory but some
minor sanding and trimming me be needed for final fit. Use a hobby knife
or rotary tool with a sanding drum for clearance.
The end of the axles may have a slight bur on them from the factory. If
the wheel is hard to install, use a file to remove this bur.
Downloaded from www.Manualslib.com
E-tips
manuals search engine

rudder servo InstallatIon

Required Parts
Fuselage assembly
Metal clevis (2)
Silicone tubing
18-inch (457mm) servo extension
Required Tools and Adhesives
String
Threadlock
Side cutters
Clear tape
 1. Secure an 18-inch (457mm) servo extension to the rudder servo
using string or a commercially available connector.
 2. Center the rudder servo using the radio system. Use side cutters to
remove any arms from the horn that may interfere with the operation of
the servo.
E-tips
The rudder linkage will be connected to the hole in the servo horn 1/2-
inch (13mm) from the center of the arm as illustrated in the photo above.
 4. Remove the cover from the fuselage for the rudder servo. Set the
cover aside until needed later in this section of the manual.
Threaded rod, 2 / -inch (57mm)
1
4
2mm nut (2)
Servo with hardware (JR368)
Pliers
Phillips screwdriver: #1
Scissors
Thin CA
EN
33