Flap Servo Installation - E-FLITE PLATINUM-Serie Bedienungsanleitung

FlaP servo InstallatIon

Required Parts
Wing panel (right and left)
Receiver
Silicone tubing
2mm nut (4)
Threaded rod, 2mm x 25mm (2)
2mm x 8mm self-tapping screw
(8)
Required Tools and Adhesives
Ruler
Scissors
String
Thin CA
Mixing cup
Drill
Low-tack tape
Sanding drum
When centering the flap servo, begin by setting the throws at the trans-
mitter to 0% for both the up and down flap positions. This is done for
both 2- and 3-position flap switches.
 1. Prepare the flap servo by installing the rubber grommets and
brass eyelets as shown in the radio or servo instructions. Center the flap
servo using the radio system. Use side cutters to remove any arms from
the horn that may interfere with the operation of the servo.
The flap linkage will be connected to the hole in the servo horn 1/2-inch
(13mm) from the center of the arm as illustrated in the photo above.
Downloaded from www.Manualslib.com
Transmitter
Receiver battery
Metal clevis (4)
Servo with hardware (MC35) (2)
Hardwood block,
13mm x 10mm x 7mm (4)
Phillips screwdriver: #1
Hobby knife with #11 blade
Pencil
5-minute epoxy
Mixing stick
Drill bit: 5/64-inch (2mm)
Rotary tool
E-tips
E-tips
manuals search engine
 2. Repeat step 1 to prepare a second flap servo. Note the servos will
be identical.
 3. Use a pencil to draw two lines on the cover. The first line is along
the bottom of the cover, 3/32-inch (2.5mm) from the edge. The second line
is 7/8-inch (22mm) from the side of the cover as shown. This will center
the servo horn in the slot when using the recommended servos.
 4. Sand the 10mm x 7mm end of the block using medium grit
sandpaper. This will be the end glued to the plate in the following step.
EN
11