Center Of Gravity - E-FLITE PLATINUM-Serie Bedienungsanleitung

 3. Use clear tape to secure the interior inside the canopy.
You can add more detail to the Habu 32 cockpit by painting parts of the
cockpit with different colors so it looks more realistic.

center oF gravIty

Required Parts
Assembled airframe
Required Tools and Adhesives
Balancing stand
CAUTION: Do not inadvertently skip this step or property damage
and injury could occur.
When balancing your model, adjust the motor battery as necessary so
the model is level or slightly nose down. This is the correct balance point
for your model. You should find the CG to be very close with the battery
installed as shown in this manual. Mark the location of the battery on the
battery tray using a felt-tipped pen so it can be returned to this position if
it is removed from your model.
After the first flights, the CG position can be adjusted for your personal
preference.
 1. Attach the wings to the fuselage following the procedure outlined
earlier in this manual. Attach the fan cover to the fuselage using the
four 2mm x 8mm self-tapping screws removed earlier and a #1 Phillips
screwdriver.
Downloaded from www.Manualslib.com
E-tips
Felt-tipped pen
manuals search engine
 2. The recommended Center of Gravity (CG) location for your model is
3 15 / to 4 1 / inches (100 to 115mm) back from the leading edge of the
16 2
wing as shown with the battery pack installed. Mark the location of the CG
on the top of the wing with a felt-tipped pen.
 3. When balancing your model, support the plane inverted at the marks
made on the top of the wing with your fingers or a commercially available
balancing stand. This is the correct balance point for your model. Make
sure your model is assembled and ready for flight before balancing.
Balancing Stand
E-tips
If you have installed retracts, balance your model with the gear down.
EN
49