8-Channel Receiver Assignments For Dx8 - E-FLITE PLATINUM-Serie Bedienungsanleitung

 2. Insert the flap harnesses and one of the 18-inch (457mm)
extensions through the hole in front of the elevator servo and into the
fuselage on the right side as shown. Run the other 18-inch (457mm) servo
extension inside the hole on the left side of the fuselage. The leads will
exit toward the top of the fuselage above the intake. Secure the leads
using tape or tie-wraps to keep them from interfering with the operation of
the elevator servos.
The 18-inch (457mm) servo extensions reach the wing roots for the
ailerons and keep the excess wire to a minimum. If you will be taking the
Habu 32 apart often, connect a 3-inch (76mm) servo extension to each
of the 18-inch (457mm) servo extensions to ease assembly.
 3. (Optional Retracts) Prepare the retract harness by securing a 6-inch
(152mm) and 9-inch (228mm) extension to the retract harness using
string or a commercially available connector. This will plug into the retract
channel of the receiver.
 4. Plug the leads for the rudder, elevator, ailerons, flaps, nose wheel
servo and speed control into the receiver at this time. All the extensions
should now be connected to the receiver.
Downloaded from www.Manualslib.com
E-tips
manuals search engine
8-channel receIver
assIgnMents For dx8
Throttle Speed Control
Aileron Right Aileron
Elevator Elevators (Y-harness)
Rudder Rudder
Gear Flaps (harness from step 1)
Aux 1 Left Aileron
Aux 2 Gear (optional) (harness from step 3)
Aux 3 Nose Gear Steering
E-tips
Programs for the Habu using the DX8 are available for download on the
Spektum website.
 5. Use scissors to cut a small piece of hook and loop tape. Use the tape
to secure the receiver in the fuselage.
 6. Use scissors to cut a small piece of hook and loop tape. Use the tape
to secure the remote receiver in the fuselage.
EN
47