E-FLITE PLATINUM-Serie Bedienungsanleitung Seite 14

EN
 15. Use four 2mm x 8mm self-tapping screws and a #1 Phillips
screwdriver to secure the flap servo cover to the wing.
 16. Use a hobby knife with a #11 blade to trim two 1/4-inch (6mm)
pieces from the silicone tubing.
Always use threadlock on metal-to-metal fasteners to prevent them from
vibrating loose.
 17. Assemble the flap linkage using the two pieces of tubing from
the previous step, two 2mm nuts, two metal clevises and the 2mm x
25mm threaded rod. The length of the rod will be adjusted in the following
steps.
14
Downloaded from www.Manualslib.com
E-tips
manuals search engine
 18. Use the radio system to center the flap servo. Connect the metal
clevis to the outer hole of flap servo horn. The remaining clevis connects
to the flap control horn. Adjust the length of the linkage so the flap is set
to the mid/takeoff position of 11mm. Once the length of the linkage has
been adjusted, slide the tubing over the forks of the clevises to keep them
from accidentally opening in flight. Use needle nose pliers to tighten the
nuts against the metal clevises.
 19. Set the switch at the transmitter to the UP flap position. Adjust the
flap system values of the transmitter for the up position until the flap is
aligned with the aileron. This will be the UP flap position.
 20. Set the switch at the transmitter to the DOWN flap position. Adjust
the ATV at the transmitter for the down position until the flap is 25mm
below the aileron. This will be the DOWN flap position.
E-tips
Because there can be minor differences in control horn and servo posi-
tions, do not connect the linkage as described in steps 19 and 20 to the
opposite flap until you have checked the throws. Doing so may cause the
servo to bind in the UP position, which could cause damage to the flap
servo.