Optional Main Landing Gear Doors - E-FLITE PLATINUM-Serie Bedienungsanleitung

EN
 19. Check the operation of the retract using the radio system. The
wheel will retract into the center of the wheel well. If not, slightly bend
the strut so it does.
 20. Repeat steps 1 through 19 to install the remaining main landing
gear and wheel.

oPtIonal MaIn landIng gear doors

Required Parts
Wing assembly (right and left)
Receiver
Landing gear door (2)
Landing gear door block (4)
Required Tools and Adhesives
Rotary tool
Sanding block
Ruler
Pin vise
Canopy glue
Thin CA
Phillips screwdriver: #0
NOTE: The installation of the landing gear doors is optional and they can
be installed at any time during the life of your model.
 1. Use a pencil to draw a centerline on the unpainted side of the
landing gear door.
24
Downloaded from www.Manualslib.com
Transmitter
Receiver battery
2mm x 8mm self-tapping screw
(8)
Sanding drum
Medium grit sandpaper
Pencil
Drill
Drill bit: 1/16-inch (1.5mm)
Side cutter
manuals search engine
 2. Draw two lines on the door that are 7/8-inch (22mm) and 2
inch (65mm) from the top edge of the landing gear door as the center
lines for the mounting blocks.
 3. Use a pin vise and 1/16-inch (1.5mm) drill bit to drill four holes in
the landing gear door that are 3/16-inch (5mm) from the centerline along
the lines drawn in the previous step.
 4. Use a straight edge or ruler to lightly bend the landing gear door
so it will rest tightly against the wing when the gear are retracted. Work
slowly to avoid cracking the paint on the outside of the landing gear door.
/ -
5
8