Elevator Servo Installation - E-FLITE PLATINUM-Serie Bedienungsanleitung

EN

elevator servo InstallatIon

Required Parts
Fuselage assembly
Y-harness
2mm nut (4)
Pushrod support base (2)
Pushrod support standoff, R1 and
R2
Pushrod wire, 16 / -inch (412mm)
1
4
(2)
Required Tools and Adhesives
String
Thin CA
CA accelerator
Hobby knife with #11 blade
 1. Prepare the elevator servo by installing the rubber grommets
and brass eyelets as shown in the radio or servo instructions. Center the
elevator servo using the radio system. Use side cutters to remove any
arms from the horn that may interfere with the operation of the servo.
The elevator linkage will be connected to the hole in the servo that is
3/8-inch (10mm) from the center of the arm as illustrated in the photo
above.
 2. Repeat step 1 to prepare a second elevator servo. Note the servos
will be identical.
38
Downloaded from www.Manualslib.com
Servo with hardware (MC35) (2)
Metal clevis (4)
Silicone tubing
Pushrod support standoff, L1 and
L2
2mm x 8mm self-tapping screw
(4)
Scissors
Medium CA
Pliers
Phillips screwdriver: #1
E-tips
manuals search engine
E-tips
The screws for the elevator servo will go in at a slight angle so they can
be accessed by the screwdriver.
 3. Use a #1 Phillips screwdriver to thread a servo mounting
screw into the mounting holes for the elevator servo. Remove the screw
after cutting the threads in the plywood.
 4. Place 2–3 drops of thin CA in each of the holes. This will
harden the threads made by the screws making them more secure when
the elevator servo is installed.
 5. Install the elevator servo in the fuselage using the hardware
provided with the servo and a #1 Phillips screwdriver. The servo output
faces the front of the fuselage. Guide the lead from the servo over the top
of the intake and to the front of the fuselage.