Exhaust Tube And Speed Control Installation - E-FLITE PLATINUM-Serie Bedienungsanleitung

 11. Use a #1 Phillips screwdriver to thread a 3mm x 10mm self-
tapping screw into the four holes for mounting the fan unit.
 12. Place 2–3 drops of thin CA in each hole to harden the surrounding
wood. This hardens the wood, making the screws more secure.
 13. Secure the fan unit in the fuselage using four 3mm x 10mm self-
tapping screws. Tighten the screws using a #1 Phillips screwdriver.
 14. Install the elevator servo horn and pushrod support if it was moved to
install the fan housing in the fuselage. The tape can also be removed from
the bottom of the fan housing at this time.
Downloaded from www.Manualslib.com manuals search engine
exhaust tuBe and
sPeed control InstallatIon
Required Parts
Fuselage assembly
Clear tape
Speed control
Required Tools and Adhesives
Hobby scissors
Hemostats
 1. Carefully roll or fold the exhaust tube into the shape shown below. It
is made of a durable clear plastic and will not be harmed by doing so.
 2. Slide the exhaust tube into the fuselage, with the wider end of the
tube entering the fuselage from the rear. It will "pop" open when it has
been inserted fully into the fuselage.
 3. Position the exhaust tube so it overlaps onto the fan assembly.
Exhaust tube
Fan access hatch
Hook and loop tape
Felt-tipped pen
EN
43