Nose Gear Installation - Fixed Gear - E-FLITE PLATINUM-Serie Bedienungsanleitung

EN
 12. Attach the landing gear door to the strut using four 2mm x 8mm
self-tapping screws and a #0 Phillips screwdriver.
Work slowly when using a sanding drum on the screws. The screws will
heat up while sanding, which could melt the landing gear door.
 13. Use side cutters and a rotary tool with a sanding drum to smooth
the ends of the screws against the inside of the blocks. If this is not done,
the screws could catch on the edges of the retract opening and cause the
gear to not retract correctly.
 14. Slide the landing gear door so the top block is resting against the
coil of the landing gear strut. Apply a thin bead of canopy glue along the
front and back of the strut against the landing gear door. Rotate the door a
few times to work the glue behind the strut.
26
Downloaded from www.Manualslib.com
E-tips
manuals search engine
 15. Retract the landing gear using the radio system. This will set the
correct angle for the landing gear door against the wing. Allow the glue to
cure overnight before moving the gear back to the down position.
 16.Repeat steps 1 through 15 to install the second landing gear door.

nose gear InstallatIon - FIxed gear

Required Parts
Fuselage assembly
Transmitter
Receiver battery
Metal clevis (2)
Threaded rod, 2 / -inch (57mm)
1
4
3mm x 8mm socket head screw
(4)
Aluminum wheel spacer, 3.5mm
Wheel axle adapter set
Required Tools and Adhesives
Pliers
Side cutter
Clear tape
Hex wrench: 1.5mm, 2.5mm
 1. Use a #1 Phillips screwdriver to remove the four 2mm x 8mm self-
tapping screws that secure the nose gear cover to the fuselage. Set the
cover and screws aside until later in the section of the manual.
Fixed nose gear assembly
Receiver
Silicone tubing
2mm nut (2)
Servo with hardware (MC35)
Aluminum wheel collar with
setscrew, 3.5mm
Wheel, 1 / -inch (44.5mm)
3
4
Phillips screwdriver: #1
Hobby knife with #11 blade
Threadlock