Cleaning The Filter - Cleanmaxx 09107 Gebrauchsanleitung

EN

Cleaning the Filter

1. Empty the dust container (7) (see "Emptying the Dust Container"). Do not close the
bottom fl ap (19).
2. Remove the foam fi lter from the dust container.
3. Reach into the dust container. Turn the fi lter holder (21) a little until it is released and
can be removed.
20
7. Wipe out the dust container with a damp cloth if necessary.
8. Let all parts dry completely in the air before you reassemble them. IMPORTANT:
Never assemble wet or damp components or attach them to the motor unit (3)!
The device is assembled in the reverse order.
Cleaning the Motor Unit and Accessories
• Wipe off the motor unit (3), the extension tube (11), the crevice nozzle (13), the brush
nozzle (15) and the nozzle adapter (14) with a soft, moist cloth as needed. Then dry
it with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.
Cleaning the Turbo Nozzle
To make it easier to clean, the brush can be removed from the turbo nozzle (9):
Storage
• Store the device in a cool, dry place which is protected from direct sunlight and is out
of the reach of children and animals.
• To make it easier to store, hang it with the suction opening (8) facing downwards in
the wall bracket which is supplied with the device.
If the device is not going to be used for a prolonged period, remove the battery to
be on the safe side (see the "Charging Up the Battery" chapter).
4. Pull the HEPA fi lter (20) out of the fi lter holder.
5. Tap out the fi lter and the fi lter holder and clean them with
21 a soft brush if necessary.
6. Rinse the fi lter holder with clear water. IMPORTANT: Do
not use water to clean the HEPA fi lter or the foam fi lter!
1. Slide the latch fastener on the bottom of the turbo
nozzle towards the small wheel on the turbo nozzle.
2. Open the latch and remove.
3. Take out the brush and remove any contamination.
4. Reinsert the brush. When you do this, fi rst insert the end
with the star-shaped recess.
5. Insert the latch and slide the latch fastener back in place.
24