Emptying The Collecting Container And Cleaning The Filter; Troubleshooting - Cleanmaxx Z 05348 Anleitung

❐ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the de-
vice and accessories. These could damage the surfaces.
• It needs to be emptied by no later than when the collecting container is full up to the
marking, and after each use (see the "Emptying the Collecting Container and Clean-
ing the Filter" section).
• Clean the housing of the main unit if necessary using a damp, soft cloth. Dry it with
a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.
• Wash the wiping cloth in accordance with the washing instructions.
• Check the charger and its mains cable for damage at regular intervals.
• Keep the device ready for operation. Charge up the battery after each use (see the
"Charging Up the Battery" chapter).
The fi lter may lose some of its colour over time. This is normal and does not
have any adverse effect on function. However, if it is damaged or worn, it must
be replaced. You can order another new fi lter at www.service-shopping.de.

Emptying the Collecting Container and Cleaning the Filter

1. Switch off the device.
2. Carefully remove the collecting container from the main unit (see the "Assembly"
chapter, "Removing / Inserting the Collecting Container" section).
(Similar to the one shown)

Troubleshooting

If the device is not working properly, please check fi rst of all whether you are able to rec-
tify a problem yourself. Otherwise you should contact the customer service department.
Do not attempt to repair a defective device yourself!
Problem
The device only works slowly
or does not start.
Dust escapes from the de-
vice during cleaning.
05348_de-gb-fr-nl_V0.indb 26 05348_de-gb-fr-nl_V0.indb 26
3. Remove the insert and fi lter from the collecting container.
4. If you have sucked up dry dirt, empty the collecting con-
tainer into a rubbish bin. Tap the insert and fi lter out over
the rubbish bin. If there is wet dirt in the collecting con-
tainer, rinse these parts under running water.
5. Let all parts dry completely in the air before you put them
back together. CAUTION: Never re-insert the fi lter and
insert if they are still damp. The device is assembled in
the reverse order.
Possible cause/solution
• Is the battery fl at? Recharge it.
• Check whether the collecting container, insert and
fi lter are inserted correctly and adjust the fi tting if
necessary.
26
27.01.2014 10:13:58 27.01.2014 10:13:58