Cleaning The Device And Accessories; Emptying The Collecting Container And Cleaning The Filter - Cleanmaxx PC-P003W Gebrauchsanleitung

Cleaning the Device and Accessories

CAUTION!
■ Clean the fi lter after each use to maintain good performance and prevent overheating
of the motor.
■ Switch off the device before doing any cleaning of the device and make sure that it
is not connected to the mains power.
■ Keep the main unit, the charger and the cable away from water or other liquids
to avoid electric shocks. Make sure that no liquid gets into the main unit during
cleaning. Only the collecting container, the insert, the fi lter and the suction nozzles
may be cleaned with water. However, they must be completely dry before they are
put back into the device.
■ The fi lter is neither machine-washable, dishwasher-safe nor suitable for tumble
drying! Only ever dry the fi lter in the air, and never use a hair dryer to do so.
■ Do not use any sharp or abrasive cleaning agents or cleaning pads to clean the
device and accessories. These could damage the surfaces.
• It needs to be emptied by no later than when the collecting container is full up to
the marking, and after each use (see the "Emptying the Collecting Container and
Cleaning the Filter" section).
• Clean the housing of the main unit if necessary using a damp, soft cloth. Dry it with
a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.
• Wash the wiping cloth in accordance with the washing instructions.
• Check the charger and its mains cable for damage at regular intervals.
• Keep the device ready for operation. Charge up the battery after each use (see the
"Charging Up the Battery" chapter).
The fi lter may lose some of its colour over time. This is normal and does not
have any adverse effect on function. However, if it is damaged or worn, it must
be replaced.

Emptying the Collecting Container and Cleaning the Filter

1. Switch off the device.
2. Carefully remove the collecting container from the main unit (see the "Assembly"
chapter, "Removing / Inserting the Collecting Container" section).
(Similar to the one shown)
25
3. Remove the insert and fi lter from the collecting container.
4. If you have sucked up dry dirt, empty the collecting
container into a rubbish bin. Tap the insert and fi lter out
over the rubbish bin. If there is wet dirt in the collecting
container, rinse these parts under running water.
5. Let all parts dry completely in the air before you put them
back together. CAUTION: Never re-insert the fi lter and
insert if they are still damp. The device is assembled in
the reverse order.
EN