Cleaning The Hepa Filter - Cleanmaxx Cycloon Power Pro Gebrauchsanleitung

Cleaning the HEPA Filter

The HEPA fi lter is located in the fi lter unit in the dust container and should be cleaned
regularly to ensure that the suction power of your vacuum cleaner does not diminish and the
motor is not overloaded.
5. Tap the HEPA dust fi lter out over an open dustbin. Clean the fi lter using a brush if neces-
sary. Never clean the HEPA fi lter with water to prevent damage to the fi lter!
6. Tap the foam fi lter out over an open dustbin. If necessary, you can rinse the foam fi lter
with clear, cold water. Then allow the fi lter to dry completely before you insert it again.
7. Place the dry foam fi lter back into the fi lter unit.
8. Insert the HEPA fi lter back into the fi lter unit.
9. Close the dust container lid. The fastener clip must be heard to lock in place.
1. Hold down the release button on the handle of the dust
container and detach the dust container from the vacuum
cleaner.
2. Open the dust container by releasing the fastener clip (A)
and folding up the dust container lid.
A
3. Remove the HEPA fi lter (B) by pulling it out.
B
4. Below the HEPA fi lter there is another foam fi lter. Remove it
for cleaning.
32