Emptying The Dust Container And Cleaning The Filter; Storage - Cleanmaxx 00142 Gebrauchsanleitung

Emptying the Dust Container and Cleaning the Filter

1. Switch off the device.
2. Detach the motor unit (5) from the dust container (12): Hold the device with the dust
container (12) at the bottom. Grip the dust container (12), press the release but-
ton (13) and remove the motor unit (5) (see the "Assembly" chapter, "Inserting / Re-
moving the Dust Container" section).
3. Hold the dust container (12) over a dustbin.
7. Tap out both parts and clean them with a soft brush if necessary.
8. The fi lter and the plastic parts can also be rinsed with clear, lukewarm water.
CAUTION: Do not use any cleaning agents!
9. Let all parts dry completely in the air before you reassemble them. CAUTION: Never
assemble wet or damp components or attach them to the motor unit (5)! The
device is assembled in the reverse order.
10. Attach the dust container (12) to the motor unit (5): First insert the two locking lugs on
the fl at side of the motor unit (5) into the matching openings in the dust container (12)
and then press the two components together. The dust container (12) must be heard
to engage in place.
Cleaning the Turbo Nozzle
To make it easier to clean, the brush can be removed from the turbo nozzle (7):
1. Press the release button on the turbo nozzle (7) and remove it.
2. On the bottom of the turbo nozzle (7) slide the

Storage

00142_de-en-fr-nl_A5_V1.indb 23 00142_de-en-fr-nl_A5_V1.indb 23
23
4. Pull the fi lter mount out of the dust container (12) (see
picture).
5. Empty the dust container (12).
6. The fi lter mount contains a small basket that protects the
HEPA fi lter. Twist the small basket a little bit and remove it.
3. Flip open the catch (see picture).
4. Take out the brush and remove any contamination.
5. Reinsert the brush: First insert the end with the triangular
recess, then the end with the metal pin.
6. Flip the catch shut and slide the
tion.
1. Insert the cordless vacuum cleaner into the frame (6).
2. Hook the frame (6) into the charging station (23).
3. If necessary, fold back the stem (15) to save space.
4. Connect the charging station (23) to the mains power.
switch in the direction.
switch in the
EN
direc-
19.09.2016 12:37:48 19.09.2016 12:37:48