Ordering Spare Parts - Tractel tirak L 500 P Serie Original-Montage- Und Betriebsanleitung

– Lower the overload to the ground.
– Raise the overload again.
The load limiting device must react. Otherwise repeat the procedure.
The load limiting device must not react when the hoist is loaded to the working load limit.
– Load the load lifting equipment with the maximum working load.
– Raise until the load lifting equipment hangs freely.
The load limiting device must not react when lifting the load.
If the load limiting device reacts:
– Lower the load to the ground.
– Insert a screwdriver into the setting screw (3).
– Screw the setting screw (3) out by one half turn.
– Raise the load again.
The load limiting device must not react when lifting the load.
If setting screw (3) was adjusted, repeat the test with the maximum overload.
– Load the load lifting equipment with the calculated overload.
– Raise the load.
The load limiting device must react and stop the UP travel of the hoist within the first 10 cm.
– Tighten the lock nut (5) with the socket wrench.
– Replace the blanking plugs (1) and secure with red sealing wax.
8.6

Ordering spare parts

Spare parts lists can be obtained from your supplier or directly from TRACTEL Greifzug GmbH.
The details needed to place the order are listed on the separate component's nameplates, see § 3.3.
The required information is e.g.:
Rope drive: Article no., tirak™ model / Tractel
Motor: Article no., Motor model
Brakes: Article no., Type and coil voltage of the brake
Electrical controls: Number of the circuit diagram
Wire ropes: Rope diameter, construction, length, packing
Important: Maintenance tasks of any kind are only to be performed by maintenance personnel trained and certified by Tractel.
G1035.4 – 01/2019
model, rope diameter, serial number
®
ATTENTION!
Installation and operating manual
EN-55