Application Areas - Tractel tirak L 500 P Serie Original-Montage- Und Betriebsanleitung

Installation and operating manual
Swivel pulleys, hooks, shackles and eyes and other optional carrying devices belonging to the product are only to be used together
with this product.
The load must be guided by on-site means.
If the load cannot be guided by on-site means then a rotation-resistant wire rope with a swivel hook or a rope swivel must be used.
Swivel hook and rope swivel must turn freely when subjected to loads.
Health and safety requirements
Tractel declares that the machine described in this instruction manual complies with technological safety standards that were
applicable to the equipment in the European Union when it was launched on the market by the manufacturer.
Test reports (test certificates) are included with the product. The static and the dynamic tests are described in detail in the test reports.
The hoist is equipped with a mechanical load limiting device. When delivered, the overload can be adjusted on request in accordance
with the order specification for the planned use but will never exceed 1.25 x WLL. The setting of the load limiting device must be
checked in the scope of the annual safety inspection of the hoist.
The putting into service of the machine is prohibited unless the machine in which the tirak™ hoist is installed complies as a whole with
the regulations of the 2006/42/EC Directive and the local regulations.
A conformity evaluation process must be run by the system manufacturer on machines used for man riding or man riding and material
handling (Directive 2006/42/EC). The harmonized standard EN 1808 must also be taken into account when inspecting the equipment.
3.3.2 Guarantee and liability exclusions
See § 7.8.
Any use other than the intended use described here will be considered as unauthorized. Tractel does not accept any liability for
damages resulting from unauthorized use. The operator must assume sole responsibility in this case. Abiding by all of the instructions
given in this instruction manual, in particular the assembly and maintenance regulations, are also considered part of authorized use.

3.3.3 Application areas

The product is suitable for use under the following operating conditions:
 For permanent or temporary installations
 Drive groups, see Illustration 1 on page 3 (footer).
Allowable temperature range see Illustration 1.

Danger of severe accidents!
– 24-hour operation is prohibited.
– Use in areas where there is a risk of explosion is prohibited.
– Use in a corrosive environment is prohibited.
– Use in close proximity to open fire or in an extremely hot environment is prohibited.
3.3.4 Structural requirements
Anchoring point
The structural equipment to be used for attaching the product must be designed in compliance with the applicable Directives and
standards.
The application's total suspended load must be taken into account regarding the design of the suspended construction. The total
suspended load is the actual suspended static load, which is made up of the rated load, the load lifting equipment's own weight, the
additional fittings, the wire ropes and the control and connection cords.
1 The performance and duty cycle of the motors may be affected when operated at altitudes over 1,000 m or temperatures over 40 °C.
Corrosion protection in accordance with order specifications
2
EN-20
1
DANGER!
2
G1035.4 – 01/2019