Electrical Safety - Parkside PLV 1500 B1 Originalbetriebsanleitung

several prong attachments,
beware that moving one prong
attachment can lead to the other
prong attachments rotating.
• When setting the machine,
make sure your fingers do not
become caught between the
moving prong attachments and
stationary parts of the machine.
• Allow the motor to cool down
before parking the machine for
a longer period.
• When servicing the prong at-
tachments, beware that the
prong attachments can be
moved even when the drive is
switched off.
• Replace worn or damaged parts
for safety reasons. Use only
original spare parts and acces-
sories.
• If the machine is stopped to
service, inspect, store or replace
an accessory part, switch off the
drive, disconnect the machine
from the mains and make sure
that all moving parts have come
to a complete stop. Allow the
machine to cool down before
carrying out inspections, settings
etc. Treat the machine with care
and keep it clean.

Electrical safety:

CAUTION! The following states
how to avoid accidents and
injuries due to electric shock:
• Before each use, carry out a vis-
ual inspection of the power and
extension cables for signs of
damage or ageing. Damaged
mains power cables increase
the risk of electric shock.
• Connect the implement to a pow-
er socket with a RCD (Residual
Current Device) that has a rated
current of not more than 30 mA.
Avoid operating the machine in
poor weather conditions, espe-
cially if there is a risk of lightning.
• Always keep the extension cable
well away from the cutting tools.
Should the power cable become
damaged during work, then
instantly disconnect the power
cable from the mains. DO NOT
TOUCH THE POWER CABLE
BEFORE IT HAS BEEN DISCON-
NECTED FROM THE MAINS!
Risk of electric shock. Do not use
the machine, if the cable is dam-
aged or worn.
• If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer,
a customer service agent of the
same or a similarly qualified per-
son in order to prevent hazards.
• Keep the extension cables away
from the sprung tines. The tines
may damage the cables and re-
sult in contact with live parts.
• Check that the mains voltage is
the same as indicated on the rat-
ing plate.
• Avoid body contact with earthed
parts (e.g. metal fences, metal
posts). There is an increased risk
of electric shock if your body is
earthed.
• Only use approved extension
cables of the type H05RN-F with
a maximum length of 75 m and
which have been approved for
open-air use. The stranded cord
diameter of the extension cable
GB IE NI
11