General Safety Instructions For Power Tools; Work Area Safety; Electrical Safety - Parkside PGSA 4 A1 Originalbetriebsanleitung

GB MT
Remove persons in the vicinity from
the danger area.
Guaranteed sound power level
Protection class III
III
Do not dispose of the device
with the battery installed in
household waste.
Symbols on the recharger
Read the manual.
Pole orientation
Safety transformer –
short-circuit proof
Switch-mode power supply
The recharger is for indoor use only.
Protection class II
(Double insulation)
Machines do not belong with do-
mestic waste.
General safety instructions
for power tools
WARNING! Read all safety direc-
tions and instructions. Omissions
in the compliance with safety directions
and instructions can cause electrical
shock, i re and/or severe injuries.
Retain all safety directions and in-
structions for future use.
The term "Power Tools" used in the safety
instructions refers to mains-operated power
58
tools (with power cord) and to battery-op-
erated power tools (without power cord).

1) WORK AREA SAFETY

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in
explosive atmospheres, such as
in the presence of l ammable
Iiquids, gases or dust. Power tools
create sparks which may ignite the
dust or fumes.
c) Keep children and bystanders
away while operating a power
tool. Distractions can cause you to
lose control.

2) ELECTRICAL SAFETY

a) Power tool plugs must match
the outlet. Never modify the
plug in any way. Do not use
any adapter plugs with earthed
(grounded) power tools. Unmodi-
i ed plugs and matching outlets will
reduce risk of electric shock.
b) Avoid body contact with
earthed or grounded surfaces,
such as pipes, radiators, ranges
and refrigerators. There is an
increased risk of electric shock if your
body is earthed or grounded.
c) Do not expose power tools to
rain or wet conditions. Water
entering a power tool will increase the
risk of electric shock.
d) Do not abuse the cord. Never
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.