probst SH-3500-B Betriebsanleitung Seite 165

Are all connections (hose clamps, etc.) tight?
Are type, load capacity and warning signs in a complete and
legible condition?
Are the operating and maintenance instructions available
and are operators familiar with them?
Check all load-bearing parts (e.g. suspension) for
deformation, wear or other damage.
Clean suction plate / Inspect for cracks,
evenness of sealing lip, etc. Replace if necessary
Has the test label been updated?
General condition of the device
Leak test
Draining the condensation water
Condition of load securing chain 1)
1) Once the load has been held by the load securing chain, the load securing chain must be properly tested and replaced if
necessary. Damaged load-securing chains must not be used any further!!
55
Interval
Daily Weekly Monthly Every
X
X
X
MAINTENANCE
Yearly
six
months
X X
X
X
X
X
X
X
X
X
X