Handling Moist Loads; Starting The Gasoline Motor; Starting With The Electrical Starter - probst SH-3500-B Betriebsanleitung

Handling moist loads

ATTENTION

Starting the gasoline motor

Starting with the electrical starter

See also the operation instructions for the gasoline motor.
1. Open the fuel valve.
35
Moisture in the vacuum pump
Vacuum pump failure
►
Before attaching to the load, remove water from the suction area.
►
After the lifting process, switch on the vacuum pump.
►
Push both red RELEASE LOAD buttons simultaneously (see warning notice in
chapter 6.6.1).
►
Let the vacuum pump run dry for at least five minutes.
► Drain condensation if necessary (see chapter 9.9).
► Turn the lifting device off.
ON
OFF
OPERATION
Fuel valve
ON