Marzhauser Sensotech Profiler ST Betriebsanleitung Seite 158

All manuals and user guides at all-guides.com
Operation on a PC
2 Select the PC Port over which the PROFILER ST is connected
3 Select the number of measuring systems (No. of axes),
4 Select the same Baud rate, which is selected in the
5 Select the Output file format which should be used when
6 Confirm your entries by clicking on the OK button.
GetPos is now configured for communication with the
PROFILER ST.
When using GetPos for the first time, it generates the configu-
ration file GetPos.cfg, in which the settings adopted by you are
saved. The configuration file is saved in the folder, in which the
file GetPos.exe is stored.
158
to your PC.
which are connected to the PROFILER ST and are enabled in
the Encoder menu.
»
Chapter 6.7.6 Encoder, page 148
PROFILER ST (factory setting: 57,600 baud).
»
Chapter 6.7.7 COM (Data / Interface), page 150
Note: The baud rate selection is only relevant for an RS-232
connection to your PC. With a USB connection, the baud
rate selection has no effect.
saving your data.
Operating Manual