Marzhauser Sensotech Profiler ST Betriebsanleitung Seite 150

All manuals and user guides at all-guides.com
Operation
Corr
Period
SAVE
ESC
6.7.7 COM (Data / Interface)
In the COM (Data / Interface) menu you can configure the
serial PC interface of the PROFILER ST and enable/disable the
button
NOTICE
Faulty data transmission and measurement from incorrect
configuration!
When the PROFILER ST and PC are connected to each other
over the RS-232 interface, you must enter the same baud rate
selected on your PC when configuring the PROFILER ST.
150
enable/disable position correction
SSI: counting step 0.0976 µm is preset
(not changeable)
TTL (RS-422): enter counting step ac-
cording to quadruple evaluation in mm
1Vss: enter period length of the input
signal in mm
save settings
return to Setup menu
.
Operating Manual