Marzhauser Sensotech Profiler ST Betriebsanleitung Seite 126

All manuals and user guides at all-guides.com
Operation
6.2.1 Current Position Values
The position display shows you the current position values of
the measuring system with respect to the most recent zero
point.
Directly after switching on the PROFILER ST,
•
•
At the factory, the number of decimal places is pre-config-
ured to 3 and the measuring unit to mm. You can, however,
individually adapt the number of decimal places and the mea-
suring unit to your needs.
»
6.2.2 General Status Display
The general status display in the right-hand, upper corner of
the touchscreen gives you information about the PROFILER ST
readiness for operation.
Should the general status display be red, contact our Customer
Service Center and give the displayed error code.
»
126
for all incremental measuring systems the position
value 0 is shown regardless of the approached position and
for all absolute measuring systems the position value of
the approached position is shown related to the absolute
machine zero.
Chapter 6.7.4 Display, page 145
Green
Red
Chapter 11 Service, page 170
The PROFILER ST is ready for operation.
The PROFILER ST is not ready for
operation. An error code is displayed
next to the red display field.
Operating Manual