Performing Measurements - Marzhauser Sensotech Profiler ST Betriebsanleitung

All manuals and user guides at all-guides.com
Operation

6.3 Performing Measurements

NOTICE
Possible malfunction from incomplete commissioning!
Before you can take measurements with the PROFILER ST, you
must have fully commissioned the PROFILER ST.
»
X
1 If the position correction is configured for your measuring
2 Position the sample/workpiece at the position from which
3 Zero the position values with
4 Approach the desired measuring point.
Now you can read the current position values from the position
display.
128
Chapter 5 Commissioning, page 113
Performing measurements
setup, enable the position correction.
»
Chapter 6.5 Using the Position Correction, page 130
you want to perform the measurement.
Note: With a connected foot switch (optional accessory),
you can also zero the position values by pressing the left
pedal.
Operating Manual
, or .